What do I do if my display is blank?
Check the polarity on your battery to make sure it is installed according to the diagram in the battery compartment. Also
make sure that you are using a quality alkaline battery. We advise against reloading batteries.
Why is my time incorrect or not displaying at all?
This alarm clock receives a signal from Frankfurt (DCF-77) to set the clock and the calendar to atomic time. Sometimes,
due to adverse weather or atmospheric conditions you will not be able to receive a signal immediately. The best way to get
a signal is to put your alarm clock in a window facing Frankfurt until you see the tower icon appear. If definitely you are
not receiving the signal, wait one night : during the night time there are less atmospheric disturbances.
How do I manually set the time and date ?
In case the clock do not receive the DCF-77 signal, it is possible to manually set time. Proceed as follows :
1. Press the MODE key until time will start flashing. Then use the ALM1/HOUR key to set time, and the ALM2/MIN
key to set the minutes.
Once time is set, exit the manual setting mode by pressing the SNOOZE key.
How do I set the alarm?
Once the DCF-77 time signal is received or the time has been manually set, proceed as follows to set the alarm :
1. Press and hold the ALM1/HOUR key until the alarm time will start flashing (right of the screen).
2. Set the hours and minutes of the desired alarm time by using the ALM1/HOUR (hours) or the ALM2/MIN
(minutes) keys respectively.
3. Once the alarm time is set, press the SNOOZE key to confirm and exit .
The same procedure must be follow to set the second alarm time (use the ALM2/MIN key).
© La Crosse Technology 06
1/2
|