INSTALLATION INSTRUCTIONS FOR PART 99-2004
APPLICATIONS
Cadillac
1997-2001 Catera
1996-1999 Deville (Column Shift Only)
99-2004
KIT FEATURES
• DIN Radio Provision with Pocket
• ISO DIN Radio Provision with Pocket
KIT COMPONENTS
( A) Radio Housing • ( B) Trim Plate • ( C) ISO Brackets • (D) (4) Speed Clips • (E) (4) Phillips head screws
D
B
C
A
E
TOOLS REQUIRED:
Phillips Screwdriver
•
Cutting Tool
1-800-221-0932
© COPYRIGHT 2004 METRA ELECTRONICS CORPORATION
DASH DISASSEMBLY
99-2004
1997-2001 CADILLAC CATERA
Disconnect the negative battery
terminal to prevent an accidental
short circuit.
1
2
3
A
B
C
Remove (1) Phillips head screw from
inside the ashtray and remove ash-
tray. (Figure A)
Remove screw covers from the radio
trim panel. Remove traction control
and hazard switch covers. Then
remove switches by depressing tabs
and pulling outward. (Figure B)
Remove (4) Phillips head screws
from behind covers and ashtray.
4
5
Remove radio trim panel and unplug
any remaining harnesses from the
panel. (Figure C)
Remove (2) Phillips head screws
securing the radio. Unplug and
remove the radio.
6
1996-1999 CADILLAC DEVILLE
A
Disconnect the negative battery
terminal to prevent an accidental
short circuit.
1
Unsnap and remove radio trim panel.
(Open glove box to access.) (Figure A)
2
3
Pinch the side clips to disengage
radio. Unplug and remove radio.
1
KIT ASSEMBLY
1997-2001 CADILLAC CATERA
99-2004
Remove (2) tabs from the top edge
of the radio housing. (Figure A)
Remove both mounting brackets “B”
from the radio housing. (Figure B)
1
2
B
A
TWO ON EACH SIDE
OF RADIO HOUSING
DIN RADIO PROVISION
Slide the radio into the DIN
cage/housing assembly until it snaps
into place. (Figure B)
4
Slide the DIN cage into the radio
housing and secure by bending the
metal locking tabs outward. (Figure A)
3
B
A
Continue with final assembly.
5
3
ISO RADIO PROVISION
Align the holes from the ISO snap in
Slide the radio bracket assembly into
4
brackets with the holes in the side of
the radio and mount the brackets to
the radio using screws supplied with
the radio. (Figure A)
the radio housing until the assembly
snaps into place. Snap the ISO
Trimplate over the unit. (Figure B)
A
B
Continue with final assembly.
5
2
KIT ASSEMBLY
1996-1999 CADILLAC DEVILLE
99-2004
Install (4) speed clips into the sub-
dash mounting positions. (Figure A)
Remove mounting brackets “A” from
the radio housing. (Figure B)
1
2
B
A
TWO ON EACH SIDE
OF RADIO HOUSING
DIN RADIO PROVISION
Slide the radio into the DIN
cage/housing assembly until it snaps
into place. (Figure B)
4
Slide the DIN cage into the radio
housing and secure by bending the
metal locking tabs outward. (Figure A)
3
B
A
Continue with final assembly.
5
3
ISO RADIO PROVISION
Align the holes from the ISO snap in
Slide the radio bracket assembly into
4
brackets with the holes in the side of
the radio and mount the brackets to
the radio using screws supplied with
the radio. (Figure A)
the radio housing until the assembly
snaps into place. Snap the ISO
Trimplate over the unit. (Figure B)
A
B
Continue with final assembly.
5
3
FINAL ASSEMBLY
99-2004
FINAL ASSEMBLY
Locate the factory wiring harness in the dash and make the connection as shown.
Metra recomends using the proper mating adapter and making the connections as
shown. (Isolate and individually tape off the ends of any unused wires to prevent
electrical short circuit.)
1
Re-connect the negative battery terminal and test the unit for proper operation.
Reassemble radio and dash assemblies in reverse order of disassembly.
2
3
FINAL WIRING CONNECTIONS
Make wiring connections using the EIA color code chart shown below and the instructions included with the head
unit. Metra recommends making connections as shown below; Strip, Splice, Solder, Tape. Isolate and individually
tape off ends of any unused wires to prevent electrical short circuit.
A
A)
B)
C)
D)
Strip wire ends back 1/2"
Twist ends together
Solder
B
C
D
Tape
METRA / EIA WIRING CODE
12V Ignition / Acc . . . Red
Right Front (+) . . . . . Gray
12V Batt / Memory . . Yellow
Ground . . . . . . . . . . . Black*
Power Antenna . . . . . Blue
Right Front (-). . . . . . Gray / Black
Left Front (+) . . . . . . White
Left Front (-). . . . . . . White / Black
Right Rear (+). . . . . . Violet
Amp Turn-On . . . . . . Blue / White
Amp Ground . . . . . . . Black / White
Illumination. . . . . . . . Orange
Dimmer . . . . . . . . . . Orange / White
Right Rear (-) . . . . . . Violet / Black
Left Rear (+). . . . . . . Green
Left Rear (-) . . . . . . . Green / Black
*NOTE: When a Black wire is not present, ground radio to vehicle chassis.
All colors may not be present on all leads due to manufacturer’s specifications.
4
99-2004
NOTES
5
INST992004
1-800-221-0932
REV. 12/06/07
© COPYRIGHT 2004 METRA ELECTRONICS CORPORATION
INST99-2004
|